FormFutura® StoneFil
About The Materials
StoneFil is a PLA-based 3D printer filament with a 50% powdered stone filling, which give 3D printed parts true stone-like aesthetics and a rough and matt stone-like surface finish.
Materials Documentations
StoneFil is a PLA-based filament which is based on our modified and easy-to-print EasyFil PLA compound and is gravimetrically filled with 50% of powdered stone.This high “stone filling” has resulted in a 3D printer filament with remarkable aesthetic features and a significant higher material density up to 37% higher than “normal” PLA. StoneFil is an easy-to-print 3D printer filament and printed objects have an extremely matte stone-like finish.
Unique features
Easy to print
50% gravimetric powdered stone filling
±37% heavier than “normal” PLA
Matte and rough stone-like finish
General printing guidelines *
Nozzle size: ≥ 0.4mm
Layer height: ≥ 0.2mm
Flow rate: ± 110%
Print temp: ± 215 - 230° C
Print speed: Slow
Retraction: Yes ± 5mm
Heat bed: ± 0 - 60° C
Fan speed: 50-100%
Experience level: Beginner
*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.
Nozzle cleaning
When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.
Compliance *
This filament is compliant to below listed directives and regulations.
RoHS directive 2011/65/EC
REACH directive 1907/2006/EC
*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.