UNMATCHED
BED ADHESION
Designed for PEEK, Ultem™, PPSU, and other high-performance FDM polymers, this build plate glue works for nearly every filament - Nylon, ABS, PLA, PETG, PEI, PSU, and every filament we've tested so far.
WORKS ON MULTIPLE SURFACES:
Borosilicate glass, ceramic glass, PCB board, FR4, Carbon Fiber, Fiberglass, Aluminum, BuildTak™, PEI, Kapton tape, and more.
Join over with pro-users!
Easy Clean
Easy to clean and re-apply
Just ONE is Fine
Just one bottle, enough for PLA to PEEK materials
No Mess
Better grip; unlike the glue stick or hair spray style adhesive
Safe
Made from safe, non-toxic, organic compounds
Multi Build Plate Compatible
Works on Many Surfaces (glass, carbon, resins, etc)
HOW TO USE
NANO POLYMER ADHESIVE
-
Clean Glass (use water, windex, or alcohol)
-
Apply Adhesive (spread evenly on Build Area)
-
Calibrate your first layer height
-
Print Your Part
-
Remove part
HIGH TEMP
When you're extruding over 300ºC, remove the part as quickly as possible. You want the build plate and part to be HOT when you remove it -- high-temp materials contract extremely quickly when cooling, and parts can shatter glass in less than 30 seconds. This is why we made our carbon-fiber plates for high-temp materials.
LOW TEMP
When you're extruding below 300ºC, generally you can remove the part as soon as the plate cools. With materials like PLA or PETG, it usually pops itself off the plate. If it sticks too much, you can apply water around the base of the part, which will help it release. Make sure your first layer is PERFECT -- if it is too close, even without adhesives, ABS & PETG will break and chip glass.
Created by World-Leading Polymer Scientists.
PATENT PENDING - OVER A YEAR IN DEVELOPMENT
Back in January of 2018, the journey began. We went straight to the top - adhesive-specialized material scientists. Very quickly, we created the perfect adhesive, keeping high-performance materials like solidly attached to the build plate -- no mess, no wasted time, just pure grip.
Here at Vision Miner, we know how tough printing high-temperature thermoplastics can be. There’s nothing worse than starting a print job just to find out that your base layer shifted and your printer has been extruding on open air for the past five hours.
That’s why we spent almost a YEAR consulting material scientists to formulate a new nano polymer adhesive -- light years ahead of what any glue stick can do.
​
Formulated in Costa Mesa, California, we're proud to finally announce the BEST build plate adhesive for high-temperature thermoplastics. Designed specifically for PEEK and PEI, this build plate glue is our solution for adhesion with extreme pulling forces.
Withstanding pull-force pressures over 20,000 PSI, this adhesive works on multiple surfaces -- borosilicate glass, carbon fiber, PEI, and more.
What's more -- it works on PPSU, PPS, PSU, Nylon, ABS, ASA, Polycarbonate, and even more filaments. For PLA and PETG, you can use the same coating 50+ times -- and each bottle has over 300 7"x7" coatings worth of adhesive.
In store now!
Nano Polymer Adhesive,
Say Goodbye to Warping
Designed for PEEK, Ultem™, PPSU, and other high-performance FDM polymers, this build plate glue works for nearly every filament - Nylon, ABS, PLA, PETG, PEI, PSU, and every filament we've tested so far.